How to setup Scenes

This article applies to the following products:
890 Pro

Creating Scenes allows you to set the state of one or more Z-Wave devices. Once a scene is created it can then be mapped to an Activity. This allows you to set the state of one or more of your Z-Wave devices when entering an Activity.

When setting up your scenes, the following default scenes will be created:
All On: Turns all z-wave devices in all locations on.
All Off: Turns all z-wave devices in all locations off.
All 50%: Sets all dimmable z-wave devices in all locations to half.

In addition, three default scenes will be created per location. If two locations are added (e.g. Master Bedroom and Living Room), the following scenes would be added by default:

Master Bedroom On
Master Bedroom Off
Master Bedroom 50%
Living Room On
Living Room Off
Living Room 50%

To make modifications to a default scene: 

1. Click Modify Settings on your home page.
2. Click Modify under the Scenes column.
3. Click Change beside the scene. This allows you to add or remove Z-wave devices from a scene as well as adjusting the dimmable z-wave devices.
4. Click Next after making all your desired changes
5. Click Done.

To add a new Scene: 

1. Click Modify Settings on your home page.
2. Click Modify under the Scenes column.
3. Click Add Scene on the Scene Setup page.
4. Type the name of the scene in the text box provided.
5. Click Save.
6. Select the Z-Wave devices to add to the Scene .
7. Adjust the slider to set the state of the device. Far left = Off, middle = 50%, far right = On
8. Click Next.