Controlling ExpressVu

To use your Harmony remote with a Bell ExpressVu satellite receiver, the device must be set to respond to the default Remote Address (1).

To reset your Bell ExpressVu satellite receiver to the default Remote Address:

1. Press SYSTEM INFO on the receiver's front panel. The System Information screen displays on the nearby TV and shows the Remote Address.
2. Using the original  Bell ExpressVu remote, press and hold SAT on your remote control for about three seconds, until all of the mode buttons light up, and then release SAT.
3. Using the NUMBER PAD, press the 1 button.
4. Press POUND (#). If you entered the address correctly, SAT will flash three times.
5. Press RECORD. Make sure the Remote Address you see on the System Information screen is 1.
6. Press the SELECT button on the front panel to close the System Information screen.

Your Harmony remote should now control your Bell ExpressVu satellite receiver.