TECHNICAL SPECIFICATIONS
Transducer Type: Transducer Type: Condenser, pressure gradient
Polar Pattern: 9 polar patterns including cardioid, omni-directional, figure of 8, 3 sub-cardioid patterns, and 3 super-cardioid patterns
Frequency Range: 20Hz – 20KHz
Sensitivity: 19.0mV/Pa at 1kHz (1Pa = 94dB SPL)
Output Impedance: 50Ω
Rated Load Impedance: Not less than 1kΩ
Maximum SPL: 138dB SPL (2.5kΩ, 0.5% THD)
Maximum output voltage: 90V
S/N Ratio: 85.5dB-A (IEC 651)
Noise Level: 8.5dB-A (IEC 651)
Dynamic Range: 129.5dB (@2.5kΩ)
Power Requirement: +48V DC Phantom Power (IEC 268-15)
Weight: 880g
Dimensions: 290mm x 60mm
Important Notice: The Firmware Update Tool is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Logitech Preference Manager is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Logitech Control Center is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Logitech Connection Utility is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Unifying Software is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The SetPoint software is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Frequently Asked Questions
There are no products available for this section