Revue is unable to control my DISH Network Set-top box

This article applies to the following DISH Network Set-top boxes:
Duo ViP 222, Duo ViP 222K, Solo ViP 211k/211/411, Solo DVR ViP 612, Solo 381, DISH 501, DISH 508, DISH Player-DVR 510, DuoDVR 522 & 625, DuoDVR 942 and DuoDVR ViP 622/722/722K (when not using DISH Network enhanced DVR integration)

Revue uses remote address 1 (default setting) to communicate with a DISH Network Set-top box. If you have changed the default remote address, you will need to reset the Set-top box back to remote address 1. To reset your DISH Network Set-top box to remote address 1, follow the steps below:

1. Press SYSTEM INFO on the front panel of the Set-top box. The System Information screen displays on the nearby TV and shows the Remote Address.
2. Using the original remote, press and hold SAT on your remote control for about three seconds, until all of the mode buttons light up, and then release the SAT.
3. Using the number pad, press the 1 button.
4. Press pound (#). If you entered the address correctly, SAT button will flash three times.
5. Press RECORD. Make sure the Remote Address you see on the System Information screen is 1.
6. Press the SELECT button on the front panel to close the System Information screen.

Your Revue should now control your DISH Network Set-top box.