Reference: LEDs on Indoor Camera

This article applies to the following product:
WiLife Indoor Camera kit

This article applies to the following platforms:
All supported platforms

Indoor Camera
Red LED: Power / Motion Detection	Can be disabled in Werks. When enabled it is on when unit has power, blinks upon motion detection. When disabled it is always off. Cycling the power to the camera will enable it.
All three Green LEDs blinking in unison	Indicates the camera is searching for a DHCP address. (1.6 and above)
Top two green LEDs blinking in unison	Indicates camera is awaiting discovery.
Top green LED: Frame Capture	Blinks when a video frame is captured. The frequency of the blink depends on the frame rate. The frame rate is controlled by Werks and the amount of light in the picture. Normally BLINKING.
Middle Green LED: Frame processing	Blinks when Werks has discovered the camera and is pulling a video stream. Normally BLINKING.
Bottom green LED: Network activity	Blinks when a video frame is processed. The frequency of the blink depends on the frame rate. The frame rate is controlled by Werks and the amount of light in the picture. Normally BLINKING.
Indoor Camera Power Supply
Top LED: Power	On steady when unit has power. Normally ON.
Middle LED: Link status	Turns ON when “POWER LINE NETWORK” is established via detection of periodic request for channel adaptation. Normally on.
Bottom LED: Activity	Activates for duration of 250ms upon receipt of a properly addressed unicast or broadcast frame or the transmission of a frame on the power line. Normally BLINKING.
Ethernet Connector LEDs
Green LED: Link and activity light	On when link is established, blinks when transmitting or receiving Ethernet data. (Data cannot be transmitted or received if there is no link). Normally BLINKING.
Amber LED: Collision	Activates upon detection of a collision. Normally BLINKING Slowly.
USB Receiver
Top LED: Collision	LED Activates for duration of 250ms upon detection of a collision. Normally BLINKING.
Middle LED: Activity	LED Activates for duration of 250ms upon receipt of a properly addressed unicast or broadcast frame or the transmission of a frame on the power line. Normally BLINKING.
Bottom LED: Link status	LED Turns ON when “POWER LINE NETWORK” is established via detection of periodic request for channel adaptation. Normally ON.