Getting Started - WONDERBOOM PLAY

POWER ON THE SPEAKER
PRESS the power button located on the top of your speaker to turn on your WONDERBOOM PLAY. Once powered on, WONDERBOOM PLAY automatically reconnects to the last mobile device it was connected to.

PAIR YOUR PHONE TO THE SPEAKER
To put your speaker in pairing mode, PRESS AND HOLD the Bluetooth® button until you hear a tone. Go to the Bluetooth settings on your phone and select WONDERBOOM PLAY to connect. Once connected, you’ll hear an audible confirmation from your speaker.

PLAY MUSIC
Once your WONDERBOOM PLAY is on and connected to your device, just hit play to begin streaming your music.

CONTROL MUSIC
You can control the music directly from your WONDERBOOM PLAY without picking up your phone. To pause the stream, simply PRESS the center button located at the top of the speaker. Press again to resume playing. DOUBLE-PRESS the center button to skip to the next track.

ADJUST VOLUME
PRESS the “+” / “–” buttons to increase / decrease volume.

CHARGE YOUR SPEAKER

Lift the weather door to charge using a Type-C cable. The power button will blink to indicate the speaker is charging.

A wet or contaminated Type-C connector may cause excessive heat or melting and may lead to fire damage or personal injury. Always charge your speaker with a clean, dry Type-C connector.

CHECK BATTERY LEVEL

Simultaneously press the “+” and “–” volume buttons to check the speaker's battery level. An audio message will play to inform you of the current battery level. The power button will also light up to display the battery level as follows:

Normal battery (36%-100%)	White light	Audio message
Low battery (10%-35%)	Red light	Audio message
Critical battery (<10%)	Blinking red light	Audio message

DOUBLEUP

Connect two WONDERBOOM PLAYs together for a bigger sound. LONG PRESS the play/pause button on one speaker for three seconds, and you will hear a repeating tone indicating your speaker is ready for DoubleUp. Then, LONG PRESS the center button on the other speaker until you hear the same tone. When you hear a pairing tone from both speakers, your two WONDERBOOM PLAYs have paired successfully.

After pairing, LONG-PRESS the center button on either speaker to toggle between the standard mono mode (louder volume) and two-channel stereo mode.

• If you hear this confirmation tone, you are in double sound mode.
• If you hear this confirmation tone, you are in stereo mode.
  
  

LONG-PRESS the Bluetooth button on either speaker to leave DoubleUp mode.

CONNECT TO MORE DEVICES

Your UE speaker will remember the last eight devices it connected with.

Pairing additional devices

After you pair the first device, here’s how to pair additional devices:

1. Turn the speaker on.
2. Hold down the power button until you hear a tone.
   NOTE: The Bluetooth connection button will blink rapidly, indicating that the speaker is ready for pairing.
3. On your device, go to the Bluetooth menu and scan for devices.
4. Select the name of your speaker from the list of devices.

Once paired and connected, you’ll hear an audible confirmation from the speaker. Your speaker is now ready to use with the device you added.

Reconnecting to a device

To reconnect a device to your Ultimate Ears speaker after the initial pairing or after pairing another device:

1. Turn the speaker on.
2. On your device, go to the Bluetooth menu and select the name of your speaker from the list of devices.

Once reconnected, you’ll hear an audible confirmation from the speaker. Your speaker is now ready to use with the device you selected.

MULTI-HOST

WONDERBOOM PLAY can simultaneously connect with up to two Bluetooth mobile devices.
Simply pair and connect each mobile device to your WONDERBOOM PLAY, then you can take turns playing music from each device.